RECLAIMED WOOD Siding
No need to make your clients wait for the barn board siding look. Centennial Woods™ reclaimed wood siding is naturally aged on Wyoming snow fences for up to 20 years. Use our Centennial Seal™ to make the reclaimed wood moisture resistant without changing the appearance of the wood. Our rustic wood siding can be seen on homes and shops in mountain ski towns, on seaside buildings on the east and west coasts, and everywhere in between. Use for vertical wood siding, horizontal, diagonal, or chevron pattern. Mix with other materials to create a transitional, modern look. Check out our exterior photo galleries featuring commercial or residential projects.
1X6 SIDING: NATURALLY WEATHERED BOARDS
This is a nominal 1×6 weathered wood plank that has been aged on a Wyoming snow fence. These boards are made from various softwood species from the Rocky Mountain region. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.
The face is typically 5 3⁄4” varying up to 1⁄4” (5 5/8” – 5 7/8”)
Average thickness is 3⁄4” varying up to 1⁄4” (5/8” – 7/8”)
Lengths: 3′ to 16′
BEVEL LAP: OVERLAPPED BOARDS
Bevel lap is manufactured by re-sawing wood at an angle to produce a piece thicker on one edge than the other, similar to clapboard siding, with a thick butt and a thin upper edge lapped to shed water. The minimum board overlap for installation is one inch. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.
The face of the board is 4.5″
Thickness starts at 1/4″ and goes to 1/2″
Lengths: 8′ to 12′
SHIPLAP: TOUGH RABBETED BOARDS
This milling process edges the boards so they are rabbeted making the top edge of each board lap over the bottom edges of adjacent boards creating a flush joint. The bottom edge of one board will be recessed which receives the shaped or molded edge of the board next to it. Can be used for both horizontal and vertical applications. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.
The face is 4.5” and the width is 5″
Shiplap for exteriors has a thickness of 11/16″
Shiplap for interiors has a thickness of 3/8″ Lengths: 4′, 6′, and 8′
TONGUE AND GROOVE: INTERLOCKING BOARDS
Wooden planking in which adjacent boards are joined by means of interlocking ridges and grooves along their edges. A strong joint, the tongue and groove joint is widely used for re-entrant angles. The effect of wood shrinkage is concealed when the joint is beaded or otherwise molded. Tongue and Groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Tongue and Groove can be used for both horizontal and vertical applications.These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.
The face of the board is 4.5″
Thickness of 11/16″
Lengths: 3′ to 8′
CENTENNIAL-SEAL™ WATERPROOF SEALER
Centennial-Seal™ is our water based multi-surface sealant for reclaimed wood and other surfaces.
One Gallon Covers Approximately
200 – 300 Square Feet
Water-based muli-surface concentrate that is non-toxic, has zero VOCs, is UV stable, and eco-friendly. Centennial-Seal™ contains no solvents or harmful chemicals and does not have any health or safety hazards associated with current
products. Our breakthrough micro particle formula penetrates deep beneath surfaces, creating a non-filming finish without altering color or appearance.
Pet Safe Horizontal Applications Vertical Applications