RECLAIMED WOOD
SIDING

Board-on-Board, side by side, shiplap, bevel lap,board and Batten, ANd tongue & groove planks

Reclaimed wood siding that is always consistent in appearance and available year round. No need to wait years for your wood siding to look like old barn boards. Centennial Woods™ reclaimed wood siding is naturally aged as slats on Wyoming snow fences for up to a decade. Reclaimed Wyoming snow fence siding is featured on homes and shops in ski towns, coast-to-coast, and internationally. Use for vertical, horizontal, diagonal, or chevron patterns. Check out our siding in a photo gallery from episode 4 of HGTV’s Extreme Makeover Home Edition.

Planks are FSC® Recycled 100% and contribute to Credits MR3, MR4, and MR5 under LEED®.

Use Centennial Seal™ for moisture resistance without changing the appearance of the wood.

Can be pre-applied or shipped by the gallon
Lasts 10+ years
Centennial Cut-Seal™ available for raw cut edges

Reclaimed wood siding from Centennial Woods

1X6 SIDING: NATURALLY WEATHERED reclaimed wood BOARDS

This is a nominal 1×6 weathered wood plank that has been aged on a Wyoming snow fence. These boards are made from various softwood species from the Rocky Mountain region. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.

Width: 5.75 inches on average (+/- 1⁄4 inch)
Thickness: Average of 3⁄4 inches (+/- 1⁄4 inch)
Lengths: 3 feet to 16 feet

SHIPLAP: milled from reclaimed wood bOARDS

This milling process straight lines the boards so they are rabbeted, allowing the top edge of each board lap over the bottom edges of adjacent boards creating a durable, flush joint. The bottom edge is then recessed so it can receive the shaped or molded edge of the board next to it. Used for both horizontal and vertical applications. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.

Face: 4.5 inches
Thickness: 11/16 inches
Length: 8 foot maximum

TONGUE AND GROOVE siding: INTERLOCKING reclaimed wood BOARDS

Wood planks where adjacent boards are joined by interlocking ridges and grooves along the edges. Tongue and Groove is widely used for re-entrant angles in horizontal and vertical applications. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.

Face: 4.5 inches
Average Thickness: 11/16 inches
Length: 8 foot maximum

BEVEL LAP siding: OVERLAPPing reclaimed wood BOARDS

Bevel lap is manufactured by re-sawing wood at an angle to produce a piece thicker on one edge than the other. Similar to clapboard siding, but with a thick butt and a thin upper edge lapped to shed water. The minimum board overlap for installation is one inch. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.

Face: 4.5 inches
Thickness: starts at 1/4 inch and goes to 1/2 inch
Lengths: 8 feet to 12 feet

S3S: CONSISTENT THICKNESS reclaimed wood BOARDS

Wood planks with straight-edged sides and a milled, flat backside while the face of the board retains its natural weathering. S3S is commonly used for horizontal and vertical applications. These reclaimed wood boards contribute towards satisfying credits MR3, MR4, and MR5 under LEED®.

Face: 5 inches
Average Thickness: 3/4 inches
Length: 8 foot maximum

GET A QUOTE